SAFETY GUIDE
4
OPERATIONAL PRECAUTIONS
BE SURE TO READ THE MANUAL BEFORE OPERATING THE PRODUCT.
Never change wiring while power is active.
Make sure to turn OFF the power before detaching wires, or disconnecting or
connecting the connectors. Failure to observe this caution may result in
electric shock or uncontrollable operation.
Do not touch terminals immediately after turning OFF power.
- Even after the power supply is turned OFF, electric charge remains in the
driver. To prevent electric shock, perform an inspection upon confirming
that the charge voltage monitor LED on the panel is turned OFF after the
power is turned off.
- Make installation of products not easy to touch their inner electric
components.
Do not make a voltage resistance test.
- Do not perform a megger test or voltage resistance test. Failure to observe
this caution may result in damage to the control circuit of the driver.
Please consult our sales office, if you intent to make a voltage resistance
test.
Do not operate control units by means of power ON/OFF
switching.
- Frequent power ON/OFF may result in deterioration of internal circuit
elements.
- Start/stop operation should be performed via input signals.
DISPOSAL
DISPOSAL OF AN ACTUATOR AND/OR A DRIVER
All products or parts have to be disposed of as industrial
waste.
Dispose of these items as industrial waste.
To Next Page
Loading...
Need help?
General
