70
CONTENTS
CFV 100C
User Manual
Face Detection - Manual
In Manual mode, only one detection result will be displayed at most, marked with the grey
frame (1).
1
1. When a face is detected, the detection result will be displayed in the grey frame (1).
2. Make sure that the focus point is in the desired detection result area. Half-press the
shutter release button to focus on the subject. Release the shutter release button and the
camera will restart face detection and display the detection results.
• In both Auto and Manual modes, users can press the delete button under the touch
display to clear the current face detection results. Tapping the touch display to move the
focus point (when Move AF Point is enabled) can also pause the face detection. A few
seconds after the operations mentioned above, the camera will restart face detection and
display the detection results.
• If no face is detected, a normal focus point will be displayed.
To Next Page
Loading...
