40
X2D 100C
User Manual
CONTENTS
2. Focus Mode
Includes AF and MF. Refer to the Focus Modes section for more information.
3. ISO
Select ISO value. Users can also select ISO value in Live View.
4. Aperture
5. Shutter Speed
6. AE Lock (AE-L)
This icon will appear when pressing the AE-L button to enable automatic exposure lock.
7. Exposure Scale and EV
Exposure scale is the same as in Live View. Automatic Exposure Mode (A, S, P) displays
the current exposure compensation. Manual Exposure Mode displays the value of light
metering. EV on the right side of the scale displays the current exposure value.
8. Flash Exposure Compensation
This icon will appear when a flash is mounted. Tap to set the flash exposure
compensation.
9. Exposure Mode
Includes manual, aperture, shutter, program, and full auto. Refer to the Exposure Modes
section for more information.
10. Exposure Metering
Includes centre weighted, spot, and centre spot.
Centre Weighted: used for light situations where there is no particular
dominance of light or dark areas across the tonal range. This takes into
account approximately 25% of the image seen in Live View.
Spot: the sensitive area is equivalent to approximately 2.5% of the image area
(the central spot in Live View). Any parts of the image outside of this area will
not affect the exposure reading. This provides a very accurate measurement of
specific tones. Also suitable for tonal comparison measurements. Spot area is
marked in Live View and will follow any movement of the focus point.
Centre Spot: emphasizes the central section of the focusing screen equivalent
to approximately 25% of the image. This provides a balanced assessment and
is a typical choice where the main subject is in the centre of the image.
11. Drive Mode
Includes single, continuous, self timer, interval, and exposure bracketing. View or set
the shooting parameters for each mode on the right of the mode list. Refer to the Drive
Modes section for more information.
12. Remaining Frames, Storage Location, and Storage Status
Remaining Frames: displays the number of photos that can be stored to the available
storage according to the selected storage location and image format. When the
secondary storage is used as backup in the Storage settings, the location with less
To Next Page
Loading...
Need help?
General
