Chapter VIII. Cooling system
(a) Install the water pump housing gasket
(b) Align the dowel pins on the cylinder block
niya.
12. Checking the correct connection of the system pump
with holes in the coolant pump housing.
(b) Install the oil seal on the balance shaft.
(c) Place a press stop on the oil seal and press the oil seal into
the cylinder block. When installing, do not distort the stuffing
box.
(c) Install the water pump and secure with 5 bolts.
case cooling.
Note:
ÿ The gland must be clearly centered. It is forbidden to touch the sealing lip
with hands or a hard object to avoid damaging it, which can lead to oil
leakage after installation.
Note:
Clue:
ÿ Tightening torque: 10±1 Nm.
ÿ Disassembly of the coolant pump and pump housing for
prohibited.
14. Installing the balance shaft seal
13. Coolant pump installation
(a) Clean the installation surface and over
stuffing box.
41
Assembly
Machine Translated by Google
To Next Page
Loading...