48
Enable/disable auto channel selection. Auto channel
selection will automatically set the wireless channel for the
access point’s 5GHz frequency based on availability and
potential interference. When disabled, select a channel
manually as shown in the next table.
Select a range from which the auto channel setting (above)
will choose a channel.
Specify a frequency for how often the auto channel setting
will check/reassign the wireless channel. Check/uncheck the
“Change channel even if clients are connected” box according
to your preference.
Set the channel bandwidth: 20MHz (lower performance but
less interference), Auto 40/20MHz or Auto 80/40/20MHz
(automatically select based on interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
When auto channel is disabled, select a wireless channel manually:
Select a wireless channel.
Set the channel bandwidth: 20MHz (lower performance but
less interference), Auto 40/20MHz or Auto 80/40/20MHz
(automatically select based on interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
4-3-2-2. Advanced
These settings are for experienced users only. Please do not change any of the
values on this page unless you are already familiar with these functions.
Changing these settings can adversely affect the performance of your access point.
To Next Page
Loading...
Need help?
General
