HBM MX840B-R - Page 14

1 Introduction
14 A04089_07_E00_02 HBM: public MX Modules
by the MX Assistant
n AutoBoot (module configurations are retained)
With amplifiers, the following applies for each measurement channel:
n Electrical isolation
l Signal inputs electrically isolated to the voltage supply and communication
l Signal inputs electrically isolated to each other (except MX1615B-R)
n Configurable supply voltage for active sensors
n Support for TEDS technology (read, write)
n Configurable sample rate
n Configurable active digital filter (Bessel, Butterworth or Linear Phase)
n Configurable scaling (can also be saved in TEDS)
Sensors assigned using the sensor database can be calibrated via the channel and
written back into the sensor database.