HeartWare HVAD - Page 47

41
HVAD
®
Patient Manual
3.7 Setting Up Your HeartWare
™
HVAD
™
System Carrying Cases
(continued)
4. a) Fasten the clips on the Controller compartment to
secure the Controller.
b) Close the side aps.
5. a) Place each battery pack into the individual battery
compartments behind the controller.
b) Tuck the excess battery cable length inside the battery
compartment.
6. a) Close the top ap of the Patient Pack and ensure
contents are secure (Figure 67a).
b) The Controller Display screen should be visible through
the clear window (Figure 67b).
CAUTION: DO NOT pull, twist or kink the driveline or power cables, especially while sitting, getting
out of bed, adjusting the controller or power sources, or when using the shower bag.
CAUTION: DO NOT pull, kink or twist the driveline or the power cables. Special care should be
taken not to twist the driveline while sitting, getting out of bed, adjusting controller or power
sources, or when using the shower bag.
Figure 65
Figure 66
Figure 67a
Figure 67b