27 / 68
PL
SK
DE
EN
CS
HU
- inadequate braking (In case of problems when descending slopes, do not use the brakes
to regain control of the machine!!)
- machine is not suitable for the task
- ignorance of terrain conditions, especially on the slopes
- incorrect fastening and load distribution.
- overload
OPERATION
• After starting, always check that all start interlocks, controls requiring the presence of an
operator and that the knife stop device is working properly before working on the machine.
WARNING! B
Keep your hands and feet clear of rotating parts.
• Disconnect the blades whenever you‘re not using them and when driving over surfaces
other than mowed surfaces.
• Never stay near the ejection opening or point it where damage to property or personal injury
could result.
• Always keep the discharge opening clean and free. Only remove blockages and deposits
when the machine is at a standstill and the machine engine is switched off and secured
against unintentional start-up.
Be careful when pulling heavier loads
- use only an approved towing hitch
- reduce the load so the load can be safely controlled
- do not turn sharply. Be careful when reversing.
- use weights and counterweights to balance the load
• Do not carry passengers. The machine is only intended to be used by one person.
• Always look down and behind before and during reversing manoeuvres. Keep watch for
both large and small obstacles.
• For machines with hydraulics:
The hydraulic fluid may cause serious injury in the event of
leakage under pressure; if this happens seek immediate medical assistance. Never carry out
maintenance or repairs on the hydraulic circuit; such operations should be performed by
specialist and suitably equipped personnel.
• Reduce speed when the engine is not loaded or before it will shut down. If the engine is
equipped with a fuel shut-off valve, close it immediately after turning the engine off.
Before leaving the driving seat:
- disconnect the blades and wait for the blades to come to a complete stop
- go into neutral and apply the parking brake;
- stop the engine and remove the ignition key.
Disengage the blades, stop the engine, wait till all moving parts are completely stopped
and remove the ignition key:
- before removing blockages or deposits in the discharge opening
- before cleaning, checking or servicing the machine;
To Next Page
Loading...
