Working with the Nexscan F 4100/F 4200
4–26 Edition September 2000
ABC
0
During the name allocation, Newcolor allocates
ascending numbers to the slides, e.g.
Image01... Image35. However, you can also
individually change the name, e.g. for a certain
customer. This should be done before
scanning. If the count for a certain name does
not start at 01, a frame of this name and
number already exists. This can also be in a
different mounting mode, e.g. not in Slide tray
but in Direct.
More information about name allocation can
be found in the LinoColor documentation.
0
Perform an overview scan (transparent). Image
frames are created and it is automatically
detected whether the slides have been inserted
in landscape or portrait format.
0
You can now select the frames from which you
want to create low-resolution or high-
resolution scans. If you are performing low-
resolution scans, you may be able to perform
further settings for the subsequent high-
resolution scans. Then perform the high-
resolution scans.
0
Another possibility is to process the jobs by
means of JobAssistant. In this case, you will
perform an overview scan and enter all
standard settings for the jobs. You will then
select the jobs (with Ctrl + a) and plan them as
low-resolution scans (if you want to perform
further settings) or directly as high-resolution
scans. The additional procedures are described
in the Newcolor documentation.
Name Assignment
Job Assistant
To Next Page
Loading...
Need help?
General
