HEIDENHAIN TNC 620 - Page 784

Tables and Overviews | Machine-specific user parameters
20
784
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Parameter settings
False: NC program is not stopped
NC stop during tool measurement
True: NC program is stopped if breakage tolerance is exceeded
False: NC program is not stopped
Modifying of tool table during tool check and measurement
AdaptOnMeasure: Table is modified after tool measurement
AdaptOnBoth: Table is modified after tool check and measurement
AdaptNever: Table is not modified after tool check and measurement
Configuration of a round stylus
TT140_1
Coordinates of the stylus center
[0]: X coordinate of stylus center referenced to machine datum
[1]: Y coordinate of stylus center referenced to machine datum
[2]: Z coordinate of stylus center referenced to machine datum
Safety clearance over stylus for pre-positioning
0.001 to 99 999.9999 [mm]: Safety clearance in tool axis direction
Safety zone around stylus for pre-positioning
0.001 to 99 999.9999 [mm]: Safety clearance in plane perpendicular to tool axis