Chapter 3: Setup and Configuration______________________________________________________________
Changing Module Status
You change module status by using the Select button to select the module and the Power button
to change the module status.
To change module status:
1.
Press the Select button to display the status of all modules (if the LED is on, the
module is on; if the LED is off, the module is off).
2.
Press the Select button again to select the first module (UHF/GSM).
Note: When you press the Select button the LED (for the module status you are
changing) remains illuminated for 5 seconds, during which time you can use the Power
button to change the module status in step 3.
3.
If you want to change the current module’s status, press the Power button.
Note: When you press the Power button the LED (for the module status you are
changing) blinks 5 times to indicate a status change.
Repeat steps 2 and 3 for each remaining module (if desired). After a status change, the
function of the LEDs return to normal mode
To Next Page
Loading...
