17
5
After powering on, the display shows the
last flow setting.
To set a different value:
Press the buttons + / -.
To confirm the set:
Press the button OK.
6
Connect the nasal cannula to the inlet
connection of the device.
Put the nasal cannula to the patient.
7
To properly detect inspiratory effort,
intranasal tubes should not be too thin
(HERSILL advised to be flared-tipped).
Check that with each breath, a bolus of
oxygen is released (you can see on the
8
To switch off the device:
Press the button ON / OFF.
Confirm by pressing OK.
I CAUTION .
Do not connect the OXYMO device to any other regulator than the OXYMO
P-15 MICRO.
To Next Page
Loading...
