4. Web control
Web control is used for setting parameters, checking device info, and upgrading software/firmware.
To access web control, follow the steps below:
1. Connect the lidar to your PC using an Ethernet cable.
2. Complete Section 2.4 Network settings on the receiving host.
3. Enter 192.168.1.201 into your web browser.
•
Google Chrome and Mozilla Firefox are recommended.
•
Firewall port exceptions: Port 9347 (PTC), Port 80 (HTTP), and Ports 319 and 320 (PTP 1588v2)
-58-
To Next Page
Loading...
General