2.2.3. Connector use
•
Before connection, check the pins on the socket and the holes on the plug. In case of bent pins or damaged holes, stop using the
connector and contact technical support.
•
Do NOT attempt to force open a connection by pulling on the cables or by twisting the connectors in any way. Doing so can loosen the
connectors' shells, or even damage the contacts.
•
If the connector's shell is accidentally pulled off, stop using the connector and contact Hesai technical support.
•
Do NOT attempt to assemble the connector's shell and cable collet; do NOT connect a connector without its shell. Doing so may damage
the lidar's circuits.
•
For further troubleshooting, please contact Hesai's technical support or obtain work instructions from the connector manufacturer.
•
The connector is designed to withstand at least 1000 mating cycles; exceeding this number may increase the risk of connector damage.
-29-
To Next Page
Loading...
General