HEX GS-911 - Maintenance and Diagnostic Functions; Checking Battery and Ignition Power; GS-911 Remote Diagnostics

To Next Page

To Previous Page

Hex GS-911 for BMW Motorcycles

_________________________________________________________________________________________________

9 MAINTENANCE AND DIAGNOSTIC FUNCTIONS

This section shows you how to use the GS-911 to do basic vehicle

diagnostics on your BMW motorcycle under emergency conditions and

workshop conditions.

Before you do any of the procedures shown in this section:

1. Make sure the motorcycle’s ignition switch and kill switch are both

in the ON position.

2. Make sure the motorcycle’s gearbox is in the Neutral (N) position.

3. Make sure the motorcycle’s side stand is in the down position.

9.1 Checking the motorcycle’s battery power and ignition power

If the motorcycle fails to start, or its electronic systems behave strangely,

there may be a problem with the motorcycle’s battery or electrical

systems.

For instructions on how to quickly check the condition of the motorcycle’s

battery, see https://www.hexgs911.com/faq/is-my-batter-ok/.

9.2 GS-911 Remote diagnostics

You can grant other users remote control of your GS-911. This allows any

other person, anywhere in the world, to diagnose problems with your

motorcycle over the internet, even if that person does not have a GS-911.

To allow another person to control your GS-911 remotely, do the steps

that follow:

1. Click Setup  Remote GS-911 Control  Continue.

2. Do not close the Remote GS-911 Control page.

 The GS-911 software will copy a URL to your control

device’s clipboard.

3. Send the URL to the person doing remote diagnosis.

4. Instruct the person doing remote diagnostics to paste the

forwarded URL into their web browser’s address bar.

 The person doing remote diagnostics can now control your

GS-911 remotely.

IMPORTANT

All examples seen in this section are typical. Not all

functionality shown is available for all motorcycles.