HEX GS-911 - AutoScanning

To Next Page

To Previous Page

Hex GS-911 for BMW Motorcycles

_________________________________________________________________________________________________

5. To end the remote session, click Disconnect on the GS-911 user

interface.

9.3 AutoScanning

AutoScanning is the quickest, easiest way to view all fault codes that are

currently saved in the motorcycle’s on-board memory.

We recommend that you run and save a complete AutoScan on every

motorcycle you work on. This allows you to build up a historical record that

can be invaluable for future diagnostics.

To read all current fault codes using AutoScanning, do the steps that

follow:

1. Click AutoScan.

 An AutoScan report will be generated (part of a typical

AutoScan report is shown below).

IMPORTANT

The GS-911 3-pin model does not support AutoScanning.

If you are using a GS-911 3-pin, refer to Reading all current

fault codes for a chosen module for instructions on how to

view fault codes.