HEX GS-911 - Clearing Current Fault Codes

Hex GS-911 for BMW Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate 2021-2022 Page 27 of 38 GS-911 2207.2
9.7.1 Reading all current fault codes for a chosen module
This section shows how to read fault codes for individual modules only. To
read all fault codes from all modules at once, see AutoScanning.
To read all current fault codes for a single module, do the steps that
follow:
1. Specify the motorcycle model as shown in Selecting a motorcycle
series and model.
2. Select the electronic module you want to work on by clicking the
correct link in the Controller list.
 The Functions view will be shown.
3. Click the Read Fault Codes link.
 The Fault codes pane for the selected electronic module
will be shown.
To delete all current fault codes for the chosen module, see Clearing
current fault codes.
9.7.2 Clearing current fault codes
To delete all current fault codes for a single module, do the steps that
follow:
1. Go to the Navigation section for the selected module as shown in
Reading all current fault codes for a chosen module.
2. Click Clear Fault Codes  Continue.
 All stored fault codes for the chosen module will be deleted.
 If a notification is given that one or more fault codes cannot
be cleared, the problem that triggered the fault code is still
present.
3. Alternatively, you can delete all current fault codes from all
electronic modules at the same time. To do this, see
AutoScanning.
IMPORTANT
A problem that has generated a fault code may not always
be eliminated by deleting the fault code.
A fault code is only a message that tells you a problem
exists. It is not the problem itself.