Indverter V2 Manual
Issue 03 Dated 11 November 2009 S/w Ver 12.4 HEXMOTO
Controls Pvt.Ltd
4
1. GLOSSARY OF TERMS USED
Drive Module Refers to Hexmoto make Indverter V2 series controller. Term is used in
combination “Drive Module” or separately as “ Drive” or “Module” to indicate the
Indverter V2 Controller
Inverter Refers to Drive module
Display 7-Segment display unit on the drive module
Keypad 5-function keypad on the drive module
Display LEDs Refers to Individual LEDs on the Display, which indicates status of drive
IGBT Insulated Gate Bipolar Transistor
PCB Printed Circuit Board
TB Terminal block.
Control Card Is a control PCB in Drive module with control ICs, analog and digital circuits
Power TB TB for external cable connections for input 3-Phase power supply and Motor
connections
Control TB TB on the Control card for panel logic connections, Frequency/ Speed reference
input connections.. Etc.
Power Board PS&GD ( Power supply and Gate Drive) is mounted with Electrolytic capacitors,
IGBTs and Power supply components. This is mounted directly on Heat sink of
the module. Power connection TBs are brought out from this card.
Function code Refers to the programmable parameter number. For example, function code 03
refers to Main speed reference.
Parameter is a function code
Para is a function code
Data Refers to Data contained in a parameter. For example, in function code 03,
Data 0000 corresponds to speed reference from Keypad, whereas 0001
corresponds to speed reference from Analog input Vin from TB.
PWM Pulse Width Modulation
Ready to Run If there are no faults sensed by the drive and no RUN command is given, drive is
placed in Ready to Run mode indicating drive is ready to accept RUN command
Store Data is stored permanently in controller memory.
Run Inverter output pulses are enabled
Authorized Personnel trained in handling Power electronics control equipments and autho
Personnel -rized by Hexmoto for commissioning and troubleshooting of drive modules
To Next Page
Loading...