HEXMOTO Indverter V2 - Safety Precautions

Indverter V2 Manual
Issue 03 Dated 11 November 2009 S/w Ver 12.4 HEXMOTO
Controls Pvt.Ltd
5
2. SAFETY PRECAUTIONS
It is recommended that only authorized personnel be permitted to perform handling, maintenance
and inspection of the drive module.
In this manual, notes for safe operation are classified under “ WARNING” or “CAUTION” using
the symbols as shown below
WARNING
Indicates a potentially dangerous situation which, if not avoided will resul
t
in death
,
serious in
j
ur
y
or
p
ermanent dama
g
e to the machiner
y
CAUTION
Indicates a potentially dangerous situation which, if not avoided will resul
t
in minor or moderate injury and damage to the machinery and drive
controller. This symbol is also used for indicating any prohibited operation.
IMPORTANT NOTE
Throughout the manual, * symbol indicates an important note o
r
information relevant for the proper functioning of the drive system.
WARNING
• Please follow the instructions in the manual before installation and
commissioning
• Ensure to disconnect all power lines to the drive before handling or
commissioning
• After power is disconnected wait for at least 1 minute until DC bus
capacitors are fully discharged
• Use proper grounding techniques
• UVW terminals are for motor connections. Do not connect Power supply to
these terminals.
• Operation of the module is by authorized, trained personnel experienced in
handling high voltage electrical equipments and fixtures.