HIAB EFFER 35 - Driving with the Crane

3.5.3. Driving with the crane
DANGER
• Never move/drive the vehicle if there is a
load suspended from the crane.
• Before you move the vehicle:
Check that there is no pump flow to the
main control valve. The PTO or power
supply must be disengaged. The operating
system must be switched off!
• Pay attention to the width and height of the
crane in the transport position. The crane
must stay within the width of the truck.
• Make sure the stowed crane and its
equipment cannot fall, hit bridges, tunnels,
other vehicles etc.
• Pay attention to overhead power lines!
Make sure that no part of the crane ever
comes in contact with overhead power
lines.
NOTE
• For further instructions, refer to the vehicle's manual(s).
• Make sure that you always obey local traffic rules when driving with a crane.
Safety precautions and warnings
EFFER 35 37