10.2. Identification of the loader crane
The information below is to be filled in by the installer. The same information will be found on the
serial number plate on the crane:
Mark: EFFER
(0) Machine Type: CRANE
(1) Model: ..........................................
(2) Serial number: .............................
(3) Manufact. year: ............................
(4) CE mark
10.3. Daily inspection checklist
Operator Document ID:
Crane s/n: Date:
DAILY INSPECTION Comments
Presence of signs and symbols
Locking devices
Spirit level
Shafts, locking shafts, bearings and bushings
Crane structure
Hooks
Lifting accessories, interchangeable equipment and
optional crane components
Electronic components
Security seal wires
Hydraulic system and oil level in the tank
Rack and pinion
FUNCTIONAL TESTS
Emergency stop buttons
Levers on the main control valve
Levers on the controller (if present)
Horn and flashing light test
TRI (Transport Report Interface)
If you find a fault that prevents you from operating the crane safely, contact an authorised service workshop. Do not try to
repair the fault, it can cause you injury or you can damage the equipment.
Permission to reproduce this checklist is granted; however please note that only the original document owned by Hiab will
contain necessary amendments and updates. Hiab shall not be held liable if the copy in your possession does not contain the
latest changes.
Technical Data
92 EFFER 35
To Next Page
Loading...
