NOTE
Always lubricate after cleaning the crane.
WARNING
Keep the devices to go into the control station (handles, supports, platforms...)
clean from oil, grease and dirt to prevent slipping and falling.
8.3.1. Daily inspection
NOTE
Refer to the daily inspection checklist at the end of this manual to photocopy.
Presence of signs and symbols
• See chapter "Safety precautions and warnings" under section "Signs on the crane". Make sure
that all the signs shown in section "Signs on the crane" are in position and in good condition.
• Make sure that all the symbols on your crane are in good condition.
Locking devices
• Make sure that all locking devices are undamaged and working properly.
• Make sure that all locking devices are properly locked.
Spirit level
• Make sure that the spirit level is clearly visible to the
operator and works correctly.
Shafts, shaft locking, bearings and bushings
• Check that the shafts, shaft locking, bearings and bushings are undamaged and working
properly.
Emergency stop buttons
• Check that the emergency stop buttons are undamaged and working properly.
Levers on the main control valve
• Check that the levers operate smoothly.
• Check that the levers return to neutral position.
Maintenance and Service
74 EFFER 35
To Next Page
Loading...
