HIAB EFFER 35 - Page 4

5. Starting crane operation ........................................................................ 52
5.1. Starting operations .................................................................... 52
5.2. Set the stabiliser system .............................................................. 54
5.2.1. Stabiliser system and ground conditions ................................. 54
5.2.2. Activate the stabiliser system .............................................. 55
5.2.3. Extend the stabiliser extensions ........................................... 55
5.2.4. Set the stabiliser legs ....................................................... 56
5.3. Operate the boom system out of transport position ............................... 57
5.3.1. How to operate the boom system ......................................... 58
6. During operation ................................................................................. 59
6.1. Hook assembly ........................................................................ 59
6.2. Controlling the crane speed with the controller SCANRECO [option] ........... 59
6.3. Pressure gauge ........................................................................ 60
6.4. Manual extensions [if installed] ...................................................... 61
6.5. Hydraulic couplings [option] .......................................................... 63
7. Ending crane operation ......................................................................... 65
7.1. Operate the boom system into transport position .................................. 65
7.1.1. How to operate the boom system ......................................... 65
7.2. Placing the stabiliser system in the transport position ............................ 66
7.3. Switching off the system .............................................................. 68
7.4. Emergency operation ................................................................. 68
7.4.1. Crane movements in an emergency ...................................... 68
7.5. Transport warning ..................................................................... 69
8. Maintenance and Service ....................................................................... 71
8.1. Service .................................................................................. 71
8.2. Warranty ................................................................................ 72
8.3. Follow the maintenance instructions! ............................................... 72
8.3.1. Daily inspection .............................................................. 74
8.3.2. Monthly inspection and maintenance ..................................... 78
8.3.3. First check ................................................................... 78
8.3.4. Annual maintenance ........................................................ 79
8.4. Lubrication .............................................................................. 79
8.4.1. General greasing of the cranes ............................................ 79
8.4.2. Lubrication schedule ........................................................ 81
8.4.3. Lubrication of the upper and lower slewing bearing ..................... 81
8.4.4. Lubrication of the boom system ........................................... 82
8.4.5. Grease on the stabiliser extensions ....................................... 83
8.4.6. Lubrication of the hooks .................................................... 83
8.5. Checking and topping up oil levels .................................................. 84
8.5.1. Oil tank / Hydraulic oil ....................................................... 84
8.6. Replacement of filters ................................................................. 86
8.6.1. Inlet filter for remote-controlled cranes ................................... 87
8.6.2. Breathing filter ............................................................... 87
8.7. Bleeding air from the hydraulic system ............................................. 87
9. Decommissioning ................................................................................ 89
9.1. Decommissioning a crane ............................................................ 89
10. Technical Data .................................................................................. 91
10.1. Load plate table ...................................................................... 91
10.2. Identification of the loader crane ................................................... 92
10.3. Daily inspection checklist ........................................................... 92
4 EFFER 35