Filling the oil tank with hydraulic oil
CAUTION
The oil used for filling must be clean. Do not mix different oils (a mixture will
change the oil properties).
Hydraulic oils must have been dealt with according to cleanliness requirements ISO 4406: -/16/13.
Hydraulic oil that is approved for EFFER products must comply with one of the following standards
or equivalents:
• DIN 51524 part 2HLP
• ISO L-FD
• ISO L-HM
Verify with the supplier that the quality and performance of the hydraulic oil complies with the
previous standards.
When changing from mineral oil to a non-polluting synthetic oil, or when changing to biodegradable
oil, contact an authorised service workshop.
Recommended hydraulic oils
ISO VG 32 ISO VG 46 ISO VG 68
Examples
Tellus S2 V32
Super 32
Hydrol L-HV 32
Shell TELLUS T 46
Texaco RANDO HDZ46
Agip ARNICA 46
Mobil SHC 526
Where to use them
Viscosity of oil
The viscosity of the oil is of great importance to achieve high efficiency of the hydraulic system.
The naming of the oil in the table below: 32, 46 or 68 tells the viscosity of that oil at 40°C (104°F)
(reference temperature).
Maintenance and Service
EFFER 35 85
To Next Page
Loading...
