February 2016 L000950, Version: 4.0
Page 3-21 Printer Driver Operations
Lamination Speed
Transfer Dwell Time: Adjust this control for the through-put speed of a card in seconds
per inch. Range is 5.5 to 0.8 seconds, with a default of 2 seconds.
Lamination Side
To specify the side(s) of the card to laminate select:
• No Lamination (if the laminator is not to be used)
• Laminate Front Side
• Laminate Back Side
• Laminate Both Sides
• Laminate Opposite Sides
Lamination Type
Cartridge 1 & 2: Select one of the lamination type options, according to which type of
lamination media is currently installed. Two types of overlaminates, film and PolyGuard,
are supported by the driver. Custom versions of each type are also available.
Selections are:
• Film Lamination: Select if the thermal transfer film overlaminate type is installed in
the lamination module.
• 0.6 PolyGuard Lamination: 0.6 is the patch thickness.
• 1.0 PolyGuard Lamination: 1.0 is the patch thickness.
Note: The two PolyGuard Lamination patches require different heat settings and
lamination speeds. Select the appropriate option according to the thickness of the
PolyGuard material in use.
• Registered Film Lamination
• Holographic Film Lamination
Transfer Temperature: If the checkbox to auto detect is selected, the temperature will
be automatically set. The slider can change the temperature if a different one is
required.
Automatically
Detect Installed
Laminate for Every
Print Job
Select this option for auto detection of the laminate installed. Default is enabled.
In the firmware, the values are updated on initialization and cover closing. If values in
the PRN file do not match the selected ones, the LCD displays a laminate error.
Default
Returns the transfer dwell time and temperature to the default settings for the
lamination type in use.
Group or Field Description
To Next Page
Loading...
