February 2016 L000950, Version: 4.0
Page 1-3 Specifications
1.1.5 Japan
この装置は総務省の型式指定を受けています。"
( 総務省指定番号は第 AC-12056 号です )
本製品は電波を使用した RFID 機器の読み取り?書き込み装置です。
そのため使用する用途?場所によっては、医療機器に影響を与える恐れがあります
1.1.6 Korea
이 기기는 업무용 (A 급 ) 전자파 적합기기로서 판매자 또는 사용자는 이 점을 주의하시길 바라며 , 가정 외의 지
역에서 사용하는 것을 목적으로 .
1.2 Safety Messages
1.2.1 Safety Messages - United States
Symbol Critical Instructions for Safety Purposes
Danger:
Failure to follow these guidelines results in personal injury or death.
To prevent personal injury or death:
• Reference the following safety messages before performing an operation.
• Always remove the power cord prior to performing repair procedures, unless otherwise
specified.
• Ensure only qualified personnel perform these procedures.
ESD:
This device is electro statically sensitive. Damage to the device may occur if exposing it to
static electricity discharges.
To prevent damage:
• Reference the following safety messages before performing an operation.
• Observe all established Electrostatic Discharge (ESD) procedures while handling cables
in or near the circuit board and printhead assemblies.
• Always wear an appropriate personal grounding device.
• Always remove the ribbon and cards from the printer before making any repairs, unless
otherwise specified.
• Remove jewelry and thoroughly clean hands before working on the printer.
Caution:
This symbol warns of an electrical hazard that could result in personal injury or death.
Caution:
For safety purposes, do not use Ethernet for a direct connection outside of the building.
To Next Page
Loading...
Need help?
General
