Inhibit Panel Usage Page 9-2
L000950, Version: 4.0 February 2016
9.1 Configuring Inhibit Panel (I-Panel for YMCKI Ribbon) using Workbench
1. Verify that the latest version of Workbench is installed.
2. To access Workbench click on Diagnostics on the Card tab of the printing preferences to bring
up Workbench.
3. Select the printer, then select Inhibit Panel.
4. Select the check box for whichever side, or both, the inhibit area should be on.
5. Click Rectangle or Logo.
6. Click and drag a box onto the template. Notice the logo box is shaded gray.
7. Move and size as needed.
To Next Page
Loading...
