February 2016 L000950, Version: 4.0
Page 4-7 To ol Box
4.7.1 Settings Information
Setting Description
Head Resistance
This is factory set. If the main board or the printhead is replaced then
adjust this number. Locate the Printhead Setting Number on the bottom of
the printhead. The number reads R=XXXX.
Print Left of Form (LOF)
Print the alignment card self-test.
Adjust the Print LOF up or down until the border of the LOF zero line is
showing on the edge of the card.
Measure the density square. Adjust the image density to 65% ± 1%.
Note: The 500 Series Densitometer is to be used for this measurement.
Density square set to 65% +/- 1%
LOF Zero Line
To Next Page
Loading...
