To o l B ox Page 4-8
L000950, Version: 4.0 February 2016
Setting Description
Image Darkness
Use this option to set the overall darkness of the printed image by
increasing or decreasing the amount of heat the printhead uses while
printing.
Use the up/down arrows to increase or decrease the amount of heat.
Important: If the value is set too high, the ribbon may jam or break
Print Top of Form (TOF)
Print the alignment card self-test.
Adjust the Print TOF until the green border is eliminated and the entire
transfer alignment block is as shown in the bottom graphic.
Note: Due to variation in roller alignment, the green border may appear at a
slight angle on the top of the card.
Edge of Transfer
(Green Border)
Transfer Alignment Block
Image Once Adjusted
To Next Page
Loading...
