HID FARGO HDP5000 - 8.2 Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) using the Application

February 2016 L000950, Version: 4.0
Page 8-9 Fluorescent Panel Usage
8.2 Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) using the Application
This process creates a fluorescent image on the card using a simple text string command in the badge
application.
8.2.1 Creating Fluorescent Text
1. Create a new text box in the badge application.
2. Type the text that should appear as fluorescent and put a ~T before the start of the text, with
no space after the ~T. The text will start on the card where the ~T begins.
3. Create the image (actual size) that should fluoresce in a separate drawing program and save it
as a “Grayscale” or “1-bit” bmp file
.
4. Create a new text box in the badge application, and type ~I followed by the address of the
image. When implemented on the card, the top left of the image will start at the top left of the
text box.