Fluorescent Panel Usage Page 8-10
L000950, Version: 4.0 February 2016
5. Set up the printer driver preferences. For instructions on this, see Chapter 3: Printer Driver
Operations.
6. Set the ribbon for YMCFK on the Device Options tab of the printing preferences.
Note: The auto detect button may also be used if the F-panel ribbon is currently installed.
7. In this same tab, check Dual Pass if the F-panel should print on a separate panel of film from
the YMC image.
Note: It is recommended the default dual pass option be used if the fluorescent image is used
in places where other dye is or any time the invert f panel image option is selected.
8. Check Invert F-Panel Image to create a negative of the fluorescent image. This may improve
the look of a person’s image
9. Printer will print the fluorescent bmp image at the ~I position on the card.
10. Printer will print the fluorescent text at the ~T position on the card.
To Next Page
Loading...
