Chapter 6
February 2016 L000950, Version: 4.0
Card Lamination Module
The Printer supports the attachment of an optional Card Lamination Module. Select Printer Models
Support for the attachment of an optional Card Lamination Module. This Module can be ordered
pre-installed or separate as a field upgradeable Module.
Once attached, the Card Lamination Module allows you to apply certified overlaminates for more
secure, tamper-resistant cards. This section explains all aspects of the Card Lamination Module's
operation and the overlaminate materials available.
6.1 Printer Unit: Reviewing the Card Lamination Module
WARNING: The Printer’s Transfer Roller reaches temperatures exceeding
350° F (175° C). Use extreme caution when operating the Laminator. Never touch the Transfer
Roller unless the Printer has been turned off for at least 20 minutes.
6.2 Adjusting the Lamination Placement on the Card
The Card Lamination Module provides an adjustable Lamination Placement knob that allows you to
fine-tune where the lamination is being placed on the card.
1. The Lamination Placement Adjustment Knob is the light gray knob to the right of the
Lamination Cartridges. The printer will have one or two film cartridges loaded (depending on
whether this is a Single or Dual-Side Lamination Module).
To Next Page
Loading...
