HID FARGO HDP5000 - Page 58

To o l B ox Page 4-12
L000950, Version: 4.0 February 2016
Setting Description
Film Print Take-up Tension
Important: The film drive sets the baseline for the film tension and should
not be adjusted by the reseller or the end user.
Note: Adjustments moderately change the image length.
Resin Heat Adjust
Use this adjustment for black resin text and barcodes that appear faded or
too light/dark.
Sleep Time
Use this adjustment to set the time the printer stops energizing the transfer
roller. This will conserve energy.
A setting of “0” will disable.
Note: The counter for this setting starts after standby time has elapsed.
Blush Point
The blush point is compensation during printing:
• There is no dye transfer
• There is no light gray line on a portion of the card
• It should be white
LCD Contrast Use this setting to adjust the brightness of the LCD panel.
Film Supply Transfer Tension
• Adjustments significantly change image length.
• Because of sensitivity, only small adjustments are recommended.
Note: Adjustments affect flash and smudge.
Film
Ta ke u p
Ribbon
Take up
Film Supply Ribbon Supply
Increased Setting=
High Tension
Decreased Setting =
Low Tension
Increased Setting=
High Tension
Decreased Setting =
Low Tension
Increased Setting=
Decreased Setting =
Low Back Tension
High Back Tension
Increased Setting=
Decreased Setting =
Low Back Tension
High Back Tension