HID Fargo HDP8500 - Page 4

© 2012 HID Global Corporation. All rights reserved.
4
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Reviewing the Sample String _____________________________________________________________ 103
Reviewing the ASCII Code and Character Table ______________________________________________ 104
Using the Default button ________________________________________________________________ 105
Using the Lamination tab __________________________________________________________________ 106
Selecting the Lamination Position _________________________________________________________ 107
Adjusting the Lamination Speed - Transfer Dwell Time ________________________________________ 107
Selecting the Lamination Side dropdown menu ______________________________________________ 107
Selecting the Lamination Type ___________________________________________________________ 108
Using the K Panel Resin tab ________________________________________________________________ 109
Using the Click and Drag capability ________________________________________________________ 110
Selecting “inches or mm” radio button ____________________________________________________ 110
Using the Add and Delete buttons ________________________________________________________ 110
Selecting the Full Card __________________________________________________________________ 111
Selecting the Defined Area and Undefined Area _____________________________________________ 111
Selecting the Print YMC under the K and Print K Only options __________________________________ 112
Using the Printer Supplies tab ______________________________________________________________ 113
Reviewing Information on the Supplies tab _________________________________________________ 114
Section 5: Accessing the Toolbox ____________________________________________________ 115
Selecting the Configuration tab _____________________________________________________________ 116
Using the Optional Printer Features Group Box ______________________________________________ 117
Using the Event Monitoring Group Box ____________________________________________________ 117
Reviewing the Ribbon Low message _______________________________________________________ 118
Reviewing the Laminate Low Message _____________________________________________________ 118
Using the Film Low message _____________________________________________________________ 118
Selecting the LCD Display Language _______________________________________________________ 119
Using the Printer LCD Display to set the language ___________________________________________ 119
Using the Driver to set the language_______________________________________________________ 120
Selecting the Calibrate Laminator tab ________________________________________________________ 121
Selecting the Calibrate Film tab _____________________________________________________________ 122
Selecting the Calibrate Ribbon tab __________________________________________________________ 123
Selecting the Clean Printer tab _____________________________________________________________ 124
Selecting the Advanced Settings tab _________________________________________________________ 126
Setting the Printhead Resistance _________________________________________________________ 127
Using the Print LOF (Left of Form) Option __________________________________________________ 127
Using the Image Darkness Option _________________________________________________________ 128
Using the Print TOF (Top of Form) Option __________________________________________________ 129
Using the Mag Top of Form Option________________________________________________________ 130
Using the Transfer TOF (Top of Form) Option _______________________________________________ 131
Using the Transfer EOF (End of Form) Option _______________________________________________ 132
Using the Transfer Temp Offset Option ____________________________________________________ 132
Using the Encoder Flip Angle Option ______________________________________________________ 133
Using the Print Flip Angle Option _________________________________________________________ 133
Using the Ribbon Print Take-up Tension Option _____________________________________________ 133
Using the Ribbon Print Supply Tension Option _______________________________________________ 133
Using the Film Print Take-up Tension Option ________________________________________________ 134
Using the Resin Heat Adjust Option _______________________________________________________ 134
Using the Sleep Time Option _____________________________________________________________ 134
Using the Blush Point Option ____________________________________________________________ 135
Using the LCD Contrast Option ___________________________________________________________ 135
Using the Film Supply Transfer Tension Option ______________________________________________ 135
Using the Film Take-up Transfer Tension Option _____________________________________________ 135