© 2012 HID Global Corporation. All rights reserved.
5
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Using the Film Print Supply Tension Option _________________________________________________ 136
Using the Cleaning rate Option ___________________________________________________________ 136
Using the Film Print Cooling Level Option __________________________________________________ 136
Using the Film Transfer Cooling Level Option ________________________________________________ 136
Using the EAT Disable Option ____________________________________________________________ 137
Using the Enable Ribbon Wrinkle Compensation Option_______________________________________ 137
Using the Standby Time Option __________________________________________________________ 137
Using the BEEP disable Option ___________________________________________________________ 137
Using the I Panel Heat Offset Option ______________________________________________________ 137
Using the Holo Transfer Offset Option _____________________________________________________ 137
Using the Standby Temp Option __________________________________________________________ 137
Using the Mag Hi-Co Voltage Offset Option _________________________________________________ 138
Using the Mag Lo-Co Voltage Offset Option _________________________________________________ 138
Using the Mag Flipper Angle Offset Option _________________________________________________ 138
Using the Fluorescent (F) Panel Heat Offset _________________________________________________ 138
Using the Lamination End of Form Option __________________________________________________ 138
Using the Lamination Temp Offset Option _________________________________________________ 138
Using the Lamination Bottom Takeup Option _______________________________________________ 138
Using the Lamination Top Takeup Option __________________________________________________ 138
Using the Lamination Card Backup Option __________________________________________________ 139
Using the Lamination Card Length Option __________________________________________________ 139
Using the Lamination Fan Speed Option____________________________________________________ 139
Using the Lamination Peel Off Delay Option ________________________________________________ 139
Reviewing the No Printer Connected error message __________________________________________ 139
Warming Time Delay ___________________________________________________________________ 140
Power On Ribbon Film Skip ______________________________________________________________ 140
Flipper Reject Angle ____________________________________________________________________ 140
Input Hopper Home Offset ______________________________________________________________ 140
Input Hopper Mag Offset _______________________________________________________________ 140
Transfer Image Length __________________________________________________________________ 140
Transfer Cooling Delay __________________________________________________________________ 140
Ribbon Factory Take-up _________________________________________________________________ 141
Ribbon Factory Supply __________________________________________________________________ 141
Film Factory Take-up ___________________________________________________________________ 141
Film Factory Supply ____________________________________________________________________ 141
Reviewing the Value outside the Range error message ________________________________________ 141
Section 6: Fluorescent Panel Usage __________________________________________________ 142
Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) using the Workbench _____________________ 142
Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) using the Application _____________________ 148
Section 7: Inhibit Panel Usage ______________________________________________________ 150
Using Inhibit Panel (via the Fargo Workbench Printer Utility) _____________________________________ 150
Using Inhibit Panel with an Application _______________________________________________________ 152
Generating Text Objects ________________________________________________________________ 152
Rendering Print Jobs ___________________________________________________________________ 153
Using the Test Print ____________________________________________________________________ 158
Troubleshooting the Inhibit Panel _________________________________________________________ 159
Section 8: General Troubleshooting _________________________________________________ 160
Troubleshooting - LCD and Printer Error Message Tables. ________________________________________ 160
How to use the LCD Error Message Table (example provided) __________________________________ 161
Troubleshooting with the LCD Error Message Table ____________________________________________ 162
To Next Page
