HikRobot MV-CL021-40GM - Page 110

GigE Line Scan Camera·User Manual
101
For the available camera, you can set multicast function as follows.
Steps:
1. Right click the available camera, and click Multicast Settings.
Figure 11-14 Click Multicast Settings
2. Select Role, and enter the IP Address and Port.
3. Click OK.
Figure 11-15 Set Multicast for Available Camera
For the connected camera, you can set multicast function as follows.
For the connected camera, only the Controller and Data Receiver is available.
Steps:
1. Right click the connected camera, and click Multicast Settings.
2. Enable the multicast function, and edit the IP Address and Port.
3. Click OK.