GigE Line Scan Camera·User Manual
19
Figure 7-4 Set Acquisition Mode
7.4 Set Trigger Mode
The camera has 4 types of trigger modes, including internal trigger mode, line trigger mode, frame
trigger mode, and line + frame trigger mode.
Table 7-2 Trigger Mode Principle and Parameter
Acquisition
Control >
Trigger Selector
and Trigger
Mode
Trigger Selector =Line Start
Trigger Mode = Off
and
Trigger Selector =Frame
Burst Start
Trigger Mode =Off
The camera itself generates the
triggering signals of this mode, and you
can adjust the line rate parameters
according to actual demand.
Acquisition
Control >
Trigger Selector
and Trigger
Mode
Trigger Selector =Line Start
Trigger Mode = On
and
Trigger Selector =Frame
Burst Start
Trigger Mode = Off
Under this mode, the frequency of the
external line trigger control signal
determines the line rate, and only one
line is exposed when a trigger signal is
input.
Acquisition
Control >
Trigger Selector
and Trigger
Mode
Trigger Selector =Frame
Burst Start
Trigger Mode = On
and
After receiving frame trigger signal,
camera will start to expose and
generate image data. The camera
outputs images according to current
settings. You do not need to set line
trigger signal. For max. line rate that
camera supports, please refer to the
To Next Page
Loading...
