HikRobot MV-CL021-40GM - Chapter 11 Other Functions; Device Control

GigE Line Scan Camera·User Manual
84
Chapter 11 Other Functions
11.1 Device Control
The specific device control parameters may differ by camera models.
In the Device Control attribute, you can view device information, edit device name, reset device,
etc. The specific parameters in Device Control attribute are shown below.
Table 11-1 Device Control Parameter Description
Parameter
Read/Write
Description
Device Type
Read only
It is the device type.
Device Scan Type
Read only
It is the scan type of the sensor.
Device Vendor Name
Read only
It is the name of device manufacturer.
Device Model Name
Read only
It is the device model.
Device Manufacture Info
Read only
It is the manufacturer information.
Device Version
Read only
It is the device version.
Device Firmware Version
Read only
It is the device firmware version.
Device Serial Number
Read only
It is the device serial number.
Device ID
Read only
It is the device ID.
Device User ID
Read and
write
Device name and it is empty by default. You can set
according to your preference.
 If User ID is empty, the client software displays
the device model.
 If you set it, the client software displays the
User ID you set.
Device Uptime (s)
Read only
It is the period of time when device is powered up.