HikRobot MV-CL021-40GM - Chapter 3 Interface and Indicator; Power and I;O Interface; First Type of Pin Definitions

GigE Line Scan Camera·User Manual
4
Chapter 3 Interface and Indicator
3.1 Power and I/O Interface
All GigE line scan cameras have the same 12-pin power and I/O interface, as shown below.
1
2
3
4
5
6
7
8
9
10
11
12
Figure 3-1 12-Pin Interface
But the specific pin definitions differ by camera models. Currently, two pin definitions are
available:
 The first type of pin definitions is applicable to MV-CL021-40GM, MV-CL022-40GC, and
MV-CL042-90GM/GC.
 The second type of pin definitions is applicable to other camera models.
3.1.1 First Type of Pin Definitions
Refer to the pin definitions and labels attached to the power and I/O cable to wire the device.
Table 3-1 Pin Definitions (First Type)
No.
Signal
I/O Signal Source
Description
1
GND
--
Power supply ground
2
DC_PWR
--
DC Power supply positive
3
IO_IN0_P
Line 0+
Differential input IO 0+
4
IO_IN0_N
Line 0-
Differential input IO 0-