HikRobot MV-CL021-40GM - Acquisition Burst Frame Count

GigE Line Scan Camera·User Manual
31
 If the frame trigger is enabled, the relation between trigger source and trigger related
parameters is shown below.
Table 7-4 Trigger Source and Trigger Related Parameters
Trigger Source
Parameters
Software Trigger
Hardware Trigger
Frequency
Converter Control
Free Trigger
Acquisition Burst Frame
Count
√
√
√
√
Trigger Activation
×
√
√
√
Trigger Delay
√
√
√
√
Frame Trigger Cache
√
√
√
√
Trigger Debouncer
×
√
√
√
 If the line trigger is enabled, the relation between trigger source and trigger related
parameters is shown below.
Table 7-5 Trigger Source and Trigger Related Parameters
Trigger Source
Parameters
Hardware Trigger
Shaft Encoder
Control
Frequency
Converter Control
Free Trigger
Trigger Activation
√
√
√
√
Trigger Delay
√
√
√
√
Line Trigger Cache
√
√
√
√
Trigger Debouncer
√
×
×
√
7.6.1 Acquisition Burst Frame Count
If the camera enables the frame trigger, you can set the acquisition burst frame count. Click
Acquisition Control > Acquisition Burst Frame Count, and enter Acquisition Burst Frame Count
according to actual demands. Its range is from 1 to 1023.