GigE Line Scan Camera·User Manual
81
10.22.1 Set Line Rate Ratio
You can go to Shading Correction, and set Line Rate Ratio according to actual demands. Line rate
ratio is used to adjust the ratio between the camera’s line rate and that of the actual object to
adjust the pixel deviation between upper line and lower line in images. Refer to the table below for
effect contrast.
Table 10-5 Effect Contrast
It is recommended to set line rate ratio larger than 1 when the camera’s line rate is larger than
that of the object.
It is recommended to set line rate ratio smaller than 1 when the camera’s line rate is smaller
than that of the object.
It is recommended to set line rate ratio as 1 when the camera’s line rate is equal to that of the
object.
The line rate ratio function is valid only when the camera is in TDI mode.
To Next Page
Loading...
