HikRobot MV-CL021-40GM - Set Acquisition Mode

GigE Line Scan Camera·User Manual
18
Partial Frame Discard
Abandon Extra Image
Description
Enabled
Disabled
The camera discards the entire image data.
Enabled
Enabled
The camera discards the entire image data.
Follow steps below to enable the frame timeout function.
Steps:
1. Click Acquisition Control, and enable Frame Timeout Enable.
2. Set Frame Timeout Time according to actual demands.
3. Enable or disable Partial Frame Discard and Abandon Extra Image according to actual
demands.
Figure 7-3 Set Frame Timeout
7.3 Set Acquisition Mode
The camera has 2 acquisition modes, including SingleFrame mode and Continuous mode.
 SingleFrame mode: When camera starting image acquisition, it acquires one image only, and
then stops.
 Continuous mode: When camera starting image acquisition, it acquires images continuously.
Real-time frame rate decides the acquisition frame number per second. You can stop camera
image acquisition manually.
Click Acquisition Control > Acquisition Mode, and select Continuous or SingleFrame as
Acquisition Mode according to actual demands.