HikRobot MV-CL021-40GM - Output Wiring

GigE Line Scan Camera·User Manual
54
When the NPN single-ended signal source provides signal, the wiring is shown below.
NPN Single-
Ended
Signal
Source
Camera Power
Signal Source Power
PWR
VCC
Camera Power Ground
GND
LINE*P Signal Line
R (1 KΩ to 10 KΩ)
LINE*N Hang
Signal Source Power Ground
Figure 9-16 NPN Single-Ended Input Wiring
9.4 Output Wiring
The four bi-directional I/O of MV-CL022-91GM/GC, MV-CL042-91GM/GC, and 8K cameras can be
set as output signals to trigger other devices.
 The wiring may differ by I/O signals used as differential output or single-ended output.
 Here we take one type of GigE line scan cameras as an example to introduce the input wiring.
Refer to the actual camera you got for specific appearance.
When I/O signals are used as differential output, the wiring is shown below.
Triggered
Device
Camera Power
PWR
Camera Power Ground
GND
LINE*P OUT A
LINE*N OUT Ã
Power Ground of Trigger Device
Figure 9-17 Differential Output Wiring
When I/O signals are used as single-ended output, the wirings are different according to the
voltages of the triggered device.