HikRobot MV-CL021-40GM - Chapter 4 Camera Installation; Installation Preparation; Install Camera

GigE Line Scan Camera·User Manual
7
Chapter 4 Camera Installation
4.1 Installation Preparation
You need to prepare following accessories before installation.
Table 4-1 Accessories
No.
Name
Quantity
Description
1
Lens
1
You should purchase lens separately according to the camera’s lens
mount.
2
Lens Adapter
1
You should purchase lens adapter separately according to the
camera’s lens mount and lens you use.
3
Power and I/O Cable
1
It refers to the 12-pin power and I/O cable that you need to
purchase separately.
4
Power Adapter or
Switch Power Supply
1
You should select suitable power adapter or switch power supply
according to the camera power supply and consumption. You need
to purchase it separately.
5
Network Cable
1
The CAT-5e network cable or above. You need to purchase it
separately.
4.2 Install Camera
Before you start
Make sure all the related devices are powered off during the installation.
Steps:
1. Fix the camera to the installation position, and install lens and lens adapter to the camera.
2. Use a suitable network cable to connect the camera with a switch or a network interface card.
3. Select a power supply method.
● Direct supply: Use the 12-pin power and I/O cable to connect the camera to a power adapter.
● PoE (Power over Ethernet): For the camera that supports PoE, use a suitable network cable to
connect the camera to a switch that supports PoE or a network interface card.