Note
Only if the alarm receiver center 1 is enabled, you can set the alarm receiver center 2 as the
backup channel and edit the channel parameters.
3. Select the Protocol Type as ADM-CID, EHome, SIA-DCS, *SIA-DCS, or *ADM-CID to set
uploading mode.
Note
Standard DC-09 Protocol
ADM-CID: The data presenng method of DC-09 is CID, which is not encrypted and only for
uploading alarm report.
*ADC-CID: The data
presenng method of DC-09 is CID, which is encrypted and only for
uploading alarm report.
SIA-DCS: The data presenng method of DC-09 is DCS (also called SIA protocol), which is not
encrypted and only for uploading alarm report.
*SIA-DCS: The data presenng method of DC-09 is DCS (also called SIA protocol), which is
encrypted and only for uploading alarm report.
-
ADM-CID or SIA-DCS
You should select the Alarm Receiver Type as IP or Domain name, and enter the IP/domain
name, port number, account code,
meout, re-upload mes and heartbeat interval.
Figure 4-6 SIA-DCS
AX Security Control Panel
23
To Next Page
Loading...
