HIKVISION AX DS-PWA32-HSR User Manual

Figure 4-10 EHome Registraon
2. Slide the slider to enable EHome protocol.
3. Select the Address Type as IP or Domain Name.
4. Enter IP address or domain name according to the address type.
5. Enter the port number for the protocol.
Note
By default, the port number for EHome is 7660.
6. Set an account, including the Device ID and EHome Login Password.
7. Select Communicaon Mode.
Auto
The system will select the
communicaon mode automacally according to the sequence of,
wired network, Wi-Fi network, and cellular data network. Only when the current network is
disconnected, will the device connect to other network.
Wired Network & Wi-Fi Priority
The
connecon priority order from high to low is: wired network, Wi-Fi, cellular data
network.
Wired &Wi-Fi
The system will select wired network rst. If no wired network detected, it will select Wi-Fi
network.
AX Security Control Panel
29

HIKVISION AX DS-PWA32-HSR Specifications

General

Brand	HIKVISION
Model	AX DS-PWA32-HSR
Category	Control Panel
Language	English