HIKVISION AX DS-PWA32-HSR

Note
By default, the device Hik-Connect service is enabled.
You can view the device status in the Hik-Connect server (www.hik-connect.com).
3. Enable Custom Server Address.
The server address is already displayed in the Server Address text box.
4. Select a
communicaon mode from the drop-down list according to the actual device
communicaon method.
Auto
The system will select the communicaon mode automacally according to the sequence of,
wired network, Wi-Fi network, and cellular data network. Only when the current network is
disconnected, will the device connect to other network.
Wired Network & Wi-Fi Priority
The
connecon priority order from high to low is: wired network, Wi-Fi, cellular data
network.
Wired &Wi-Fi
The system will select wired network
rst. If no wired network detected, it will select Wi-Fi
network.
Cellular Data Network
The system will select cellular data network only.
5. Oponal: Change the authencaon password.
Note
• By default, the
authencaon password is displayed in the text box.
• The authencaon password should contain 6 to 12 leers or digits. For security reasons, an
8-character password is suggested, which containing two or more of the following character
types: uppercases, lowercases, and digits.
6. Click Save.
EHome
In this secon, you can create an EHome account, and edit the IP address/domain name, port
number.
Steps
1. Click Communicaon Parameters → EHome Registraon to enter the Ehome Registraon
Sengs
page.
AX Security Control Panel
28