HIKVISION AX DS-PWA32-HSR

Note
The device in 868 MHZ may not support adding with serial No..
4) Click Add.
3.
Click
and the Output Sengs window will pop up.
Figure 4-14 Output Sengs
4. Edit the relay name and select a link event.
Note
You should set dierent parameters according to dierent linked events.
5. Enable Enable Connuous Output or set the output delay me.
Note
If the relay has linked to the wireless output module, the wireless output module informaon
will be displayed in the Enroll Wireless Output Module area.
6. Check Event Sub-Type (Only for Alarm event).
7. Check parons linked to the relay. (Zone and Manual event do not have this parameter.)
8. Click OK.
Note
Aer the relay is congured, you can click Status → Relay to view the output status.
AX Security Control Panel
34