Note
The available siren volume range is from 0 to 3 (funcon varies according to the model of
device) .
4. Check linked parons.
5. Oponal: Enable Enroll Wireless Siren and set the siren serial No.
Note
The siren in 868 MHZ may not support this funcon.
6. Set the Disconnecon Time, and the system determines connecon fault if the disconnected
duraon of the device is longer than the congured value.
7. Click OK.
Note
Aer the siren is congured, you can click Status → Siren to view the siren status.
Keypad
You can set the parameters of the keypad that is enrolled to the control panel.
Steps
1. Click Device Management → Keypad to enter the page.
2. Click to enter the Keypad Sengs page.
Figure 4-17 Keypad Sengs Page
3. Set the keypad name.
AX Security Control Panel
36
To Next Page
Loading...
