HIKVISION AX DS-PWA32-HSR

4. Check the check box to enable the
funcon of buzzer, presenng card, and arming/disarming
with keypad.
5. Check the Enable check box of Back-light O Time, and set the duraon of light o.
6. Select the keypad linked
paron.
7.
Oponal: Enable Link to Wireless Keypad and set the serial No.
Note
The keypad in 868 MHZ may not support this funcon.
8.
Set the
Disconnecn Time, and the system determins connecon fault if the disconnected
duraon of the device is longer than the congured value.
9. Click OK.
Note
•
Aer the keypad is congured, you can click Status → Keypad to view the keypad status.
• You can set the keypad password on the page of User Management → User → Operaon .
Card Reader
You can set the parameters of the card reader that is enrolled to the control panel.
Steps
1. Click Device Management → Card Reader to enter the page.
Figure 4-18 Card Reader Sengs
2. Click to enter the reader sengs page.
3. Set the card reader name.
4. Enable Buzzer.
5. Select the keypad linked
paron.
AX Security Control Panel
37